How do you smart diagnosis on an LG washer?


How do you smart diagnosis on an LG washer?

Press the POWER to turn on the washer. Place the mouthpiece of your phone between the Smart Diagnosis logo and the POWER button. After pressing the Start Diagnosis button, press and hold the TEMP button until a countdown displays on the washer. Keep the phone in place until the tone transmission has finished.

What does it mean when all lights are flashing on washing machine?

If the wash, rinse and spin function lights all flash at the same time, this would indicate a possible blockage in your filter or waste / drain pipe.

Why are all the lights flashing on my LG washing machine?

UE (or the lights from 1 to 6 all illuminated or flashing) – Washing machine has detected an imbalanced load. It’s also important to check the washing machine is stable to prevent excessive rocking and noise during the faster spin cycles.

How do I clear the OE error on my LG washer?

OE can be triggered by a kinked drain hose or a clogged drain pump filter.

  1. Check for kinked drain hose. Check behind the washer to ensure that the drain hose is not kinked or clogged.
  2. Test the drain pump.
  3. Do you hear the humming sound?
  4. Clean drain pump filter.
  5. Run tub clean cycle.
  6. Request Repair.

How do you reset a LG washing machine?

A washing machine is reset by pressing power off/on button on the control panel & disconnecting it from power board for a few minutes. Reconnect and switch on again. it can be completely cleared with all of the settings renewed.

How do you fix a flashing light on a washing machine?

All lights flashing on washing machine The pump filter will need to be cleared of any debris, and the drain hose will need to be unscrewed from the spigot to allow the excess water to be emptied out. These jobs are all easily performed by an appliance repair technician.

Why do the lights keep flashing on my washing machine?

If your washing machine detects an unbalanced or excessive wash load this will cause the spin light to flash. New machines will try to redistribute the load – but you may have to do this manually.

Why is my washing machine light blinking?

The Wash Light is On or Flashing when the water level does not change for a period of time OR water is present but the control does not detect the water level changing.

How to fix Le error code on LG washing machine?

Overloaded washer. Make sure the washer isn’t overloaded.

  • Too much detergent. If you see lots of suds in the tub,let the washer sit idle for 30 minutes so the foam dissipates.
  • Drive system obstruction. If you didn’t overload the washer and you don’t see excessive suds,check the rotation of the spin basket.
  • Loose wiring or defective drive motor.
  • What is 1E error in LG washing machine?

    Check for water in the plumbing system.

  • Ensure that the water taps are fully open.
  • Inspect the inlet valve blocking the flow of water into the washing machine tank.
  • Disconnect the strainer,clean and rinse it,as it may become clogged.
  • Check the condition of the hose.
  • How to fix the LG washer Le code [quickly]?

    Press POWER to turn the washer off.

  • Unplug the washer from the power outlet or turn the circuit breaker to the unit off.
  • With the power disabled,press and hold the START/PAUSE button for 5 seconds.
  • Plug the washer back in,or turn the circuit breaker back on.
  • What does error code CL mean on LG washer?

    – Super Rinse + Prewash – Intensive Wash + Extra Rinse – Temperature + Option – Half Load + Energy Saver