How do you adjust a Power Commander?
To adjust the buttons on your Power Commander III, follow the instructions below:
- With the ignition off, hold down all three buttons on the Power Commander III unit.
- While still holding down the buttons, turn on the ignition and start the bike.
- Release the buttons.
Does Power Commander 5 have launch control?
To Configure Launch Control for your Power Commander V Fuel Tuner, please follow the instructions below. An external switch is required to activate Launch Control. Select Power Commander Tools > Configure > Feature Enables and Selection Inputs. Select the On/Off box to enable or disable Launch Control.
How do you connect Power Commander to battery?
Connect to the battery The power commander has one black 12v connector, which goes onto the black negative battery terminal. Then, for a four-cylinder bike like this Hayabusa, there are four pairs of male and female injector connectors, which ‘tap in’ between the bike’s stock wiring harness and the injectors.
What can you do with a Power Commander?
What is a Power Commander? The Power Commander is a fuel injection and, on some models, an ignition timing adjustment unit that plugs ‘inline’ with the bike’s stock ECU (Electronic Control Unit). Changes are made to the bike’s fuel and ignition curves via the Power Commander’s onboard microprocessor.
Can you two step a motorcycle?
A two-step rev-limiter or stutter box is a common addition to drag race bikes as a way to improve the launch and 60 foot times. Here are some instructions for installing a clutch position switch required to operate a stutter box on the motorcycle.
Is the Power Commander V bike specific?
Triplej said: Yes, you can move your PCV to the other bike as both bikes use the same one (Part # 15-011). You will however need to go to the Power Commander website and download a new map to the PCV that matches your current setup for the 2012.
What does the Power Commander ignition module do?
The Ignition Module helps raise the rev limit and create timing adjustment. It installs easily to your Power Commander and uses OEM connectors to plug in-line to the stock ignition with no wiring required.
What does a Power Commander do for a motorcycle?
What does the Power Commander fuel controller do?
Product Overview. The Power Commander FC is a new plug-n-play fuel management device pre-programmed with Make/ Model specific maps. In addition the Power Commander FC has the added ability to modify or change these maps on the fly without a computer.
Can Am x3 Two Step?
An incredible advantage in racing situations, our Launch Control provides about a 2 car-length lead right from the holeshot vs a non-launch equipped vehicle. Build boost from a standstill without engaging the belt.
How do I download and install power Commander V?
Once you are on the downloads page click on the Power Commander V’s image. It will take you to the Download Center for PCV . Scroll down to the Software section and expand the menu. Then click on the download icon. Once you click on the download icon, this downloads a zip file that you can either save or open. Either one is fine.
How do I install a map on a power Commander V fuel tuner?
To install a map on a Power Commander V fuel tuner, you will need to download the Dynojet Power Commander software using a Windows computer (or a Mac running Windows). Once you install the software, it is easy to download maps from the Dynojet.com website. Watch the video below to get started!
Do I need to download Dynojet power Commander V software?
Before you can enjoy the power and fuel efficiency from your Dynojet Power Commander V, you need to take the step of downloading our Power Commander software .
Why do I need a power Commander V?
If you get new header pipes, mufflers, or air intake on your motorcycle then you need to at least do a basic re-map of your motorcycle’s electronic fuel injection (EFI), or things will not run properly. That is where the Power Commander V comes into play.