What is the best crossover frequency for tweeter?
Recommended crossover frequency table
| Speaker/System Type | Crossover Freq. & Type |
|---|---|
| Car main (full range) speakers | 56-60Hz (high pass) |
| Tweeters or 2-way speakers | 3-3.5KHz (high pass, or high/low-pass) |
| Midrange/woofer | 1K-3.5KHz (low pass) |
| 3-way system | 500Hz & 3.5KHz (Woofer/tweeter crossover points) |
What is a crossover for tweeters?
In the simplest terms, a crossover is a filter. Its job is to allow or prevent certain frequencies from passing through, as well as providing EQ and phase adjustment if necessary. This signal “traffic cop” is necessary so you don’t have the full range signal going to your tweeter, for example.
Where can I crossover a tweeter?
Short answer: the lower you can cross to a “tweeter” the better.
How do I choose a crossover frequency?
Tips for Setting the Proper Crossover Frequency of a Subwoofer
- If you know your speaker’s frequency range, set the crossover point roughly 10 Hz above the lowest frequency your speakers can handle cleanly.
- The most common crossover frequency recommended (and the THX standard) is 80 Hz.
How do you set a crossover frequency?
Set the crossover point around 10 Hz below the lowest frequency your speakers can produce without issue. (keep in mind that the most common recommendation for crossover frequency is 80 Hz). Once again, play some music. But this time, slowly turn up your receiver’s volume until you hear it begin to distort.
How do you choose a crossover frequency?
Is 100hz a good crossover?
The most common crossover frequency recommended (and the THX standard) is 80 Hz. On-wall or Tiny ‘satellite’ speakers: 150-200 Hz. Small center, surround, bookshelf: 100-120 Hz. Mid-size center, surround, bookshelf: 80-100 Hz.